User guide

20
Tones And Rings Used By The Multi 5
When your telephone is connected through Multi 5 to the outside line, you will hear the usual
public exchange tones for Ringing, Engaged (Busy), and Number Unobtainable. However, to
enable you to control the intercom and other facilities, the Multi 5 generates the following tones
of its own.
3 seconds
Internal Dial Tone
Internal Ringing Tone
Engaged Tone
Number Unobtainable & Error
Confirmation Tone
Door Phone Tone
Incoming exchange call
Internal call
BT Ring Back
Door Phone
TONES
RINGS
Dial Tone (high & low mixed)
High Tone
Low Tone
Ring
USING THE MULTI 5
13
Overview
The facilities that can be programmed are as follows:
• Change pass code
• Speed dial numbers
• Speed dial only bar
• Distinctive ring
• Door phone
• Direct line
• Disconnect clear
Changing the pass code
Any four digit combination can be used. It is recommended that if the default passcode is
changed then the new number is recorded and held in a secure place. If you forget your
passcode then contact your dealer.
To change the standard pass code:
• Lift the handset
• Dial 79 PPPP 0 NNNN
Where PPPP is the old pass code and NNNN is the new pass code
A confidence tone is returned if your entry was successful.
The default setting is 0000.
SETTING UP