User guide

Model 299 Ring Start version 9.09 page 6
if you make a mistake, press∗ button to go back and correct it
ports 01..5
will play 1 times
The default setting is 1.
0000 = key code
remember? *-no #-yes
Key code for remote control
This enables remote callers to dial # followed by this key code to gain control of the Multi-announcer.
Hold handset press #, the announcement starts to play. Press # and # again. From the 2nd menu press 7 (hidden
key) then 3 for Key Code
The key code can not be reviewed.
To change: press 4 digits, only press
# when you have memorised it, or
press ∗ to quit and continue to use the
old code.
03 Remember this
level? *-no #-yes
Security level for remote control
This enables a legitimate remote caller to regain control after 3 or more illegitimate attempts have
been made to break the code.
The default setting is 3.
Hold handset press #, the announcement starts to play. Press # and # again. From the 2nd menu press 7 (hidden
key) then 4 for Security
To review: press # then press ∗ to
quit.
To change: Select level, press #
Sets the number of correct key code entries
required after 3 false entry attempts.
Enable number of announcement plays for each caller
Hold handset press #, the announcement starts to play. Press # and # again. From the 2nd menu press 3 for
Enable
To review: press # then repeat pressing
# until you are satisfied, then press ∗
and * to quit.
To change: press 0..9, press #; select
start of range, press #; select end of
range, press #; select plays for next
range or press ∗ to quit.
0 stops answering
9 repeats playing forever
1..8 plays the number of times shown
RingTime = 00 secs
0..99
Setting the required ringing signal duration before answering
The default setting is 0
Hold handset press #, the announcement starts to play. Press # and # again. From the 2nd menu press 7 (hidden
key) then 1 for RingTime
To review: press # then press ∗ to
quit.
To change: Select time, press #
The display will not change if all ports are the same when reviewing