Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 82
• Operational – port up/down status.
• Last-change – time elapsed since last port status changed.
• Name – text field.
• Alias – text field.
• Eth-type – configured Speed/Duplex: speed (10/100/1000) and duplex (half/full)
setting.
o When Auto Negotiation Disabled – manual configuration of the speed and
duplex (for RJ45 ports: 10HD, 10FD, 100HD, 100FD, 1000HD or 1000FD; for
SFP ports: 1000XHD or 1000XFD).
• Eth-act-type – actual Speed/Duplex negotiated (if Auto-Neg enabled).
• Auto-neg – Auto negotiation enable/disable.
• Loopback-mode – enable and configure loopback on the port. External (towards
the line side) or Internal (towards the radio side) loopback are available, with or
without MAC addresses swap.
• Loopback Timeout – in seconds. Loopback will clear when timeout expires.
• Connector-type – RJ45 or SFP based on the physical port.
4.6.2 Configuring Interface Parameters
Use the set eth command, followed by the name of the interface to change the
default values of an Ethernet interface.
For example, use the following command to set Ethernet port 1 to SFP mode:
set eth eth1 eth-type 1000xfd
4.7 System Configuration and Monitoring Using the CLI
Use the show system command, to display the system parameters.
Ethernet port status for a specific interface.
Local_BU_Site>show system
system description : MH-B100-CCS-PoE-MWB
system snmpid : .1.3.6.1.4.1.31926
system uptime : 0007:20:02:36
system contact : undefined
system name : Local_BU_Site
system location : Oxford_st
system voltage : poe
system temperature : 37
system date : 2020.03.25