Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 78
• Self-mac – Base Unit’s MAC address
• SSID – Service Set Identifier (SSID) of the access point (base-unit). Default:
MultiHaul. The BU broadcasts openly its SSID.
• Password – base-unit password used for connection. Default: MultiHaul.
• Frequency – the channel number (channel2 or 3). Default: channel-2.
• Access-control –By-MAC (default) or By-Name. determines if TUs are identified
by MAC address or by configured name. Relevant for TU auto-provisioning by BU
feature.
• Guest-connection – determines if guest (unmanaged) terminals can be
associated with the base unit. If guest-connection is enabled, any TU with the
correct SSID and password can connect to the BU.
• Max-terminal-units – max number of TUs that can be connected to the BU (1 to
8). Default: 8 (max).
4.5.2 Terminal Unit Setup
Use the show terminal-unit command, to display the RF settings of the Terminal-
Unit.
Use the set terminal-unit command, to set the RF settings of the Terminal-Unit.
TU1> show terminal-unit
terminal-unit self-mac : 00:24:a4:07:47:14
terminal-unit ssid : MultiHaul
terminal-unit password : MultiHaul
terminal-unit connection-mode : auto-connect
terminal-unit name : F644206660
terminal-unit status : connected
terminal-unit frequency : channel-2
terminal-unit base-unit mac : 00:24:a4:07:48:74
terminal-unit tx-mcs : 8
terminal-unit rssi : -52
terminal-unit signal-quality : 95
terminal-unit tx-throughput : 0
terminal-unit rx-throughput : 0
terminal-unit connect-time : 0000:01:26:03
• Self-mac – Terminal Unit’s MAC address