Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 77
dest
ip address in the form X.X.X.X where X is a decimal number from 0 to 255
(for example, 10.0.15.74).
next-hop
ip address in the form X.X.X.X where X is a decimal number from 0 to 255
(for example, 10.0.15.74). All IP addresses in the table must be different.
prefix-len
ip prefix – a number from 0 to 32
By default, no route is defined.
To set a static route, use the following command:
Local_Site>set route 1 dest 192.168.0.64 prefix-len 30 next-hop
192.168.0.66
To set a single default gateway, use the following command. When single IP is used and
a Static route is not used, you may configure a default IP gateway. In such case, use
0.0.0.0 as the destination network with prefix-len 0.
set route 1 dest 0.0.0.0 prefix-len 0 next-hop 192.168.0.254
To display all the currently configured routes and their attributes, use the show route
command:
Local_Site>show route
ip 1 dest : 0.0.0.0
ip 1 prefix-len: 0
ip 1 next-hop : 192.168.0.254
4.5 RF Settings and Provisioning
4.5.1 Base Unit Setup
Use the show base-unit command, to display the RF settings of the Base-Unit.
Use the set base-unit command, to set the RF settings of the Base-Unit.
Local_Site>show base-unit
base-unit self-mac : 00:24:a4:07:48:74
base-unit ssid : MultiHaul
base-unit password : MultiHaul
base-unit frequency : channel-2
base-unit access-control : by-name
base-unit guest-connection : enable
base-unit max-terminal-units : 8
base-unit tx-throughput : 0
base-unit rx-throughput : 0