Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 75
• Location – text string.
• Voltage – input voltage and indication DC or PoE (R/O).
• Temperature – system temperature in C⁰ (R/O).
• Date & Time – Date [YYYY.MM.DD], Time [HH:MM:SS]
• Cli-timeout – timeout for auto-logoff.
• Loop Permission – control the permission to perform system loopbacks.
• Terminal units Isolation (Base Unit only) – when checked, packets coming from
one TU and received by BU will not be transmitted to any other TU, isolation the
traffic of each TU from neighboring TUs.
• Eth Ports Isolation – when checked, packets coming from one port of the radio
will not be transmitted to any other ports of the TU (only towards the radio
ports and the management host), isolation the traffic of each Eth port from
other Eth ports.
• Unit Mode – Normal or Low-Power. Use Low-Power for bench testing only, when
distance between radios is up to few meters. Default: Normal.
• Remote Config (Terminal Unit only) – enable auto-provisioning of TUs by BU.
Default: Disabled.
• Leds Turn Off Time – when value entered (in minutes), the radio Leds will turn
off automatically after the set time (up to 6000 minutes). To turn on the Leds,
reboot the radio. If left blank, Leds will not turn off automatically (default).
Use the set system name command to set the ODU’s name. Once you set the ODU’s
name, a prompt appears with the name you just set, the date, and the time.
Default> set system name Local_Site
Local_Site>
To set system date & time, use the following command:
Local_Site> set system date 2017.12.13 time 15:08:00
4.4 Configuring System IP Addresses Using the CLI
The MultiHaul™ radio supports up to four IP addresses that can be on different subnets
and associated with different VLANs. You can assign a static route to each IP address.
The Default IP-Gateway is defined as a static route.
By default, one IP address is defined (IP #1):
• IP Address – 192.168.0.1
• IP network Prefix – 24