Operation and Maintenance Manual
MultiHaul™ Installation, Operation and Maintenance Manual
Page 73
Figure 4-1 Launching CLI
2. PuTTY configuration (Recommended):
a. Go to category: Terminal -> Keyboard
Set Backspace key = Control-H
Set The function keys and keypad = Linux
b. Go to category: Window
Set Lines of Scrollback = 100000
c. Save the session and configuration. Give it a name and Click Save. The session
will be stored under the Saved Sessions.
3. When prompted, enter the username and password. Default: admin and admin.
login as: admin
MH, S/N: F626500012, Ver: MH-1.0.0 20211
admin@192.168.0.1's password:
4.2 General Configuration Commands: Save, Reset, Rollback
Whenever you make changes to the ODU configuration, you must save the configuration
changes to the startup configuration. If you do not save the configuration, the changes
will be lost the next time the system is reset. Use the following command to save
configuration changes to the startup configuration:
Local_Site> copy running-configuration startup-configuration
To reset the system, use the reset system command. You must reset the system
whenever you exit Alignment mode.
Local_Site> reset system