Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 72
4 Setup and Monitoring Using the Command Line
Interface
This chapter explains how to perform basic configuration tasks using the Command Line
Interface (CLI).
The CLI provides interface for configuration and monitoring. Includes the entire
configuration options of the system.
• General format of CLI command:
command object <object-id(s)> [attribute-name <attribute-value>]
for example:
set eth eth1 eth-type 1000FD
show eth all statistics
• Typical commands:
Set, show, clear, reset, run, copy
• General CLI conventions:
o Confirmation after each command correctly entered.
o Error-message with hint in case of wrong command
o Use Tab for Auto-complete
o Use Up Arrow and Down Arrow to display command history
o Use ? for help on possible configuration options and for exact command
syntax.
4.1 Establishing a CLI Session with the ODU
1. Launch SSH client. You can use any common, open source SSH client program,
such as PuTTY, available for download from the web.
Open an SSH session to the system’s IP address. The system’s default IP address
is 192.168.0.1.