Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 65
Figure 3-31 Network Page: LLDP (Configuration)
LLDP can be configured for each one of the Ethernet ports, including the radio port(s).
LLDP information may be sent over VLAN or without VLAN (untagged).
To configure LLDP
• Port – Eth1-Eth3, Eth-tu1…
• Admin – enabling LLDP on the port. Select rx-tx to enable LLDP. Note that you
may work with uni-directional LLDP by selecting rx or tx only.
• VID – VLAN ID that LLDP messages will be sent on. Default is none (untagged).
• IP Index – Lowest, Highest or IP index (1-4). The IP address the system will
respond with in the LLDP information reply. Default is Lowest.
To monitor LLDP status
Figure 3-32 Network Page: LLDP (Port Status)
Note:
By default, LLDP is disabled on the radio port and on all Ethernet line ports).
When LLDP is disabled on all ports (including radio ports), LLDP packets will pass
transparently over the radio.