Manualshelf

Operation and Maintenance Manual

ManualsBrandsMultiHaul ManualsElectronicsPoint-to-Multipoint wireless V-Band system
61626364656667686970
MultiHaul™ Installation, Operation and Maintenance Manual
Page 61
• Syslog Server
When set, all system's event and alarms will be sent to the Syslog server.
Syslog servers listens on Port 514.
3.8.3 Maintenance
Figure 3-28 Network Page: Maintenance
This section allows monitoring and configuring the following parameters:
• Connectivity
Enter target IP address and click Ping or Trace Route to test connectivity. Pop-up
screen will display the results.
• Iperf Test
Built-in Iperf client/server for TCP/UDP test over the link.
Configure one side as Server and run it (click Start) and remote end as Client
(and enter the server IP address). Note that Iperf test run in parallel to traffic
over the link.
You may test a cluster of BU and multiple TUs by setting a server on the BU side
and independent clients on each TU.
Pop-up screen will display the results.
Typical internal Iperf results are 1.4-1.5 Gbps aggregate (total).
Remember that max data-rate per TU is 1Gbps.
• ARP Table