Operation and Maintenance Manual
MultiHaul™ Installation, Operation and Maintenance Manual
Page 56
3.7.3.5 Configuration Management
Figure 3-24 System Page: Maintenance – Configuration Management
This section allows configuring the following parameters:
• Default Configuration – Click Restore to delete current startup-configuration.txt
file. After reboot, the system will come up with the factory default
configuration.
• Startup Configuration – Click Show to view (pop-up screen) the startup-
configuration.txt file. The startup-configuration file lists the commands that
build the configuration the system will come up with after reboot.
Click Load to load a new startup-configuration file that will replace the current
file and will be used after next system reboot.
When clicking Load, the system will look for a file named startup-
configuration.txt at the home directory and will store it in the file system as the
new startup-configuration file. After next reboot, the system will come up with
the new configuration.
3.7.4 Event Configuration
Figure 3-25 Network Page: Event Configuration
The system supports masking of individual/group alarms and events. In case alarm is
masked, it is not displayed in the Active Alarms and Event Log and no trap is sent.
• Event The event/group of events to be configured.
• Trap Checkbox to enable sending SNMP trap for this event.