Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 50
3.7.2 Advanced Settings
Figure 3-19 System Page: Advanced Settings
This section allows monitoring and configuring the following parameters:
• System Uptime – R/O field. Time elapsed from last power on.
• Voltage – R/O field. Input voltage and indication of PoE input.
• HW Version – R/O field.
• Contact – user configurable info (default – blank).
• Location – user configurable info (default – blank “ “).
• Unit Mode – Normal or Low-Power. Use Low-Power for bench testing only, when
distance between radios is up to few meters.
• Remote Config (Terminal Unit only) – when enabled, TU will obtain its
configuration from the BU (refer to TU Auto-Provisioning feature).
• Leds Turn Off Time – when value entered (in minutes), the radio Leds will turn
off automatically after the set time (up to 6000 minutes). To turn on the Leds,
reboot the radio. If left blank, Leds will not turn off automatically (default).
• PSE (PoE Out) – for supporting models only.
• Remote Config (Terminal Unit only) – enable auto-provisioning of TUs by BU.
Default: Disabled.