Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 46
3.6 Eth Ports Configuration and Monitoring
The Ethernet ports parameters and monitoring are managed in the Eth Ports page.
The MultiHaul™ system has up to four fixed Ethernet interfaces:
• Host – Internal management interface (relevant for VLAN settings)
• Eth1 – ODU interface, port 1
• Eth2 – ODU interface, port 2 (model dependent)
• Eth3 – ODU interface, port 3 (model dependent)
In addition, RF interfaces are allocated based on the number of units connected.
On Base Units, RF interfaces are created when remote TUs are connected or set.
The default Ethernet RF interfaces are named eth-tu1, eth-tu2…eth-tu8. On a
Terminal Unit, one RF interface is available. The Ethernet RF interface is named eth-
bu1.
This chapter includes the following topics:
• Settings
• Advanced Settings
3.6.1 Settings
Figure 3-15 Eth Ports Page: Settings