Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 45
• Not Sync – not running.
• Remote Config Disabled – remote TU is not set to accept config from BU
• Disconnected – TU is disconnected.
3.5.5 Maintenance
Figure 3-14 Radio Page: Maintenance
This section allows monitoring and configuring the following parameters:
• Loopback –enable loopback on the bridge’s RF port. Internal (towards the line
side) loopback is available with MAC addresses swap.
• Loopback Timeout – in seconds. Loopback will clear when timeout expires.
Refer to the Diagnostics chapter of this manual for detailed description of the system’s
loopbacks.