Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 43
3.5.3 Scan Results (Terminal Unit Only)
Figure 3-12 Radio Page: Terminal Scan Results
On “Connection Mode = Scan-only” or when terminal unit is not associated to a base
unit (link down), the automatic frequency scan results will be displayed.
It provides the details of the received networks, including SSID, MAC, Frequency and
Signal Strength.
By clicking Connect you will be asked to provide the password and then the link
will go up.
3.5.4 TU Auto-Provisioning
The configuration of a TU can be managed and stored in the BU, even when the TU
is not connected (example: TU pre-provisioning or replacement). The configuration
information is sent to the TU upon (re)connection if the TU is configured to allow
remote configuration (“Remote Config” is enabled on System->Settings page).
The auto-provisioning of the TU can be based on TU MAC address or name. The TU
name is identical to its serial number by default and is changeable in the GUI if
needed.
Note: TU Auto-Provisioning is available for managed TUs only.
Configuration received and implemented from the BU will be recorded in the user-
activity log under user: admin.
Auto-provisioning of remote TU is available for the following parameters:
• IP Address(es)
• NTP
• Authentication Mode (AAA)
• Ethernet ports