Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 42
o Managed – TUs that are set to ‘managed’ reserve their RF port settings and
will allow settings of services.
Note:
TUs connected as ‘guests’ will be displayed only in case they are connected. TU that
went offline and then up again, might be displayed with different RF port.
TUs connected as ‘managed’ will be displayed even if they are down and will not
change their RF port.
• Eth Port – name of the RF port that is used for connection. BU: eth-tu1, eth-
tu2…eth-tu8. TU: eth-bu1.
• Tx MSC – the Adaptive Modulation & Coding Scheme (A-MCS) which is used to
transmit the packets. MCS values: 1 to 8 (MCS 10 for very short links). MCS 0 is
used to carry control messages only (no data traffic).
• Signal Quality – the signal’s quality indication. Values: 0 to 100.
• RSSI – Receive Signal Strength Indication (in dBm). Available as long as the TU is
connected.
• Tx Rate Limiter – User may set rate limiter to limit the data rate on the radio
from BU towards the TU. Value in Mbps. Default is ‘up-to-TU-license’, meaning
the rate limiter will be set to the value of the TU data rate license and cannot be
set to a higher value even if the BU data rate license is higher.
Note:
The TU’s Tx rate Limiter, meaning the max data rate the TU transmits towards the BU
is determined by the TU configured capacity license (Data Rate set on System-
>Maintenance->Licensing page).