Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 41
o Scan only (Terminal Unit only) – TU will scan and present all visible BUs
(without connecting to any of them, even if SSID/password match). User will
then be able to select which BU to connect to.
Note that when link to BU is down, the TU will be in ‘scanning’ mode and will
present its scan results.
• Access Control (Base Unit only)
o By-MAC or By-Name. determines if TUs are identified by MAC address or by
configured name (relevant for TU management by BU feature).
• Throughput – the transmitted and received throughput over the RF interface (in
Mbps).
• MAC (R/O) – radio’s MAC address.
3.5.2 Remote Terminals (Base Unit Only)
Figure 3-11 Radio Page: Remote Terminals
From the Base Unit you can provision the remote Terminal Units.
This section allows monitoring and configuring the following parameters:
• MAC Address – radio MAC address of the remote TU/BU.
• Name – text string representing the name of the remote TU. Default: Serial
Number of the remote TU.
• Association – guest or managed.
o Guest – TUs that are connected as ‘guest’ do not require setting on the BU
side. An RF port will be created in case TU is connected.
No services configuration is supported for ‘guest’ TUs (transparent bridge
only).
Note:
Either MAC Address or Name will be available for configuration, depending on the
Access-control setting on the Radio-Settings page (By-MAC or By-Name).