Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 40
3.5 Radio Configuration and Monitoring
The radio link parameters and radio link monitoring are managed in the Radio page.
This chapter includes the following topics:
• Settings
• Remote Terminals
• Maintenance
• Scan Results
3.5.1 Settings
Figure 3-10 Radio Page: Settings
This section allows monitoring and configuring the following parameters:
• SSID – Service Set Identifier (SSID) of the BU. Default: MultiHaul.
The BU broadcasts openly its SSID.
• Password – password used for authentication. Default: MultiHaul.
• Frequency – the channel number (channel2 or 3). Default: channel-2.
Frequency setting is available for BU only. The TU will scan and be able to
connect to a BU on all channels. The TU will present the frequency channel it is
on.
• Connection Mode
o Guest-connection (Base Unit only) – determines if guest (unmanaged) TUs
can be associated with the BU. If guest-connection is enabled, any TU with
the correct SSID and password can connect to the BU, up to the maximum
number of supported TUs.
o Auto-Connect (Terminal Unit only) – TU will connect automatically to BU in
case SSID/password match.