Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 38
• Auto Negotiation – checkbox to enable auto-neg.
• Speed/Duplex – speed (10/100 or 1000) and duplex (half/full) setting:
o When Auto Negotiation Enabled – R/O field indicating the current
speed/duplex
o When Auto Negotiation Disabled – allows configuring the speed/duplex.
o R/O field indicating the current speed/duplex (note that for SFP ports, only
1000 speed is available).
• Speed/Duplex (SFP) – 1000XFD (for 1Gbps) or 2500XFD (for 2.5Gbps) SFPs.
Click Next to continue or Back to return to previous section.
3.4.4 Quick Configuration: Step 4 – Network
Figure 3-9 Quick Config Page: Step 4 – Network
This section allows configuring the following parameters:
• IP Address
The MultiHaul™ units support up to four management IP addresses that can be
associated with different VLANs. IP address may be Static or acquired by DHCP.
o # - Index (1-4)
o Type – Static or DHCP
o IP Address – Default is 192.168.0.1
o IP Prefix Length – Default is 24 (equivalent to Mask of 255.255.255.0)