Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 37
This section allows configuring the following parameters:
• SSID – Service Set Identifier (SSID) of the BU. Default: MultiHaul.
The BU broadcasts openly its SSID.
• Password – password used for authentication. Default: MultiHaul.
• Frequency – the channel number (channel2 or 3). Default: channel-2.
Frequency setting is available for BU only. The TU will scan and be able to
connect to a BU on all channels.
• Connection Mode
o Guest-connection (Base Unit only) – determines if guest (unmanaged) TUs
can be associated with the BU. If guest-connection is enabled, any TU with
the correct SSID and password can connect to the BU, up to the maximum
number of supported TUs.
o Auto-Connect (Terminal Unit only) – TU will connect automatically to BU in
case SSID/password match.
• Access Control (Base Unit only)
o By-MAC or By-Name. determines if TUs are identified by MAC address or by
configured name (relevant for TU management by BU feature).
• MAC (R/O) – radio’s MAC address.
3.4.3 Quick Configuration: Step 3 – Eth Ports
Figure 3-8 Quick Config Page: Step 3 – Eth Ports
This section allows configuring the following parameters:
• Port status visual display (Green – port is up).
• Port Type – RJ45 or SFP
• Port Enable – checkbox to enable the port.