Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 35
3.3.3 Rollback
A safety measure that allows recovering from system configuration changes that caused
loss of communication.
When Rollback is used, a timer runs (and restarts) whenever a management (or CLI)
command is entered. If no command is entered within the timeout period, the system
automatically reboots and comes up with the saved startup configuration.
A Rollback timeout is especially recommended when configuring remote elements that
are being managed over the link.
Rollback is activated for both local and remote(s) systems.
3.3.4 Reboot
Separate buttons for local and remote reboot. The system will power off and then on
and come up after initialization (~120 seconds).
Note that any unsaved changes will be lost.
3.3.5 Copy to Remote
You can find the Copy to All Remote button next to some configuration
parameters or sections. This function copies configuration to remote system based on
the changes on the local system.
Figure 3-5 Copy to all >> button