Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 34
3.3 General Configuration Commands
3.3.1 Apply
Any configuration change is executed upon clicking Apply.
The Local-Remote (and multiple remotes in case of multiple Terminal Units) concept of
the Web-Based Management allows configuring both local and remote systems of the
link.
The Apply button is available at the bottom of each configuration page (one button for
both local and remote systems).
When clicking Apply, the configuration changes will be sent to remote system(s) first
and then to the local system. If multiple parameters changed on the page before clicking
Apply, all parameters are sent in bulk to the system and then executed locally in order
to avoid losing management connection.
3.3.2 Save Configuration
Any configuration change applied should be saved using the Save Configuration
button.
The system has two configuration banks:
1. Running Configuration – the currently active configuration. Every time you click
Apply, the Running Configuration is updated.
2. Startup Configuration – the configuration the system will come up with after the
next reboot. This configuration may be different than the currently active
configuration (Running Configuration).
In order to save the applied configuration changes, click Save Configuration so
changes will be saved to the startup configuration. If changes are not saved to the
startup configuration, they will be lost the next time the system reboots.
Save Configuration and Save All Remotes Configuration buttons are
available for local and remote systems.
Note:
To view logs, pop-ups must be enabled and allowed on your Internet Browser.