Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 26
2.7.2 Weatherproofing the Cables
Before inserting a cable connector into the ODU, you must first enclose the cable
connector in a protective All-Weather shell. Three sets of All-Weather shells are
provided with the ODU for the ODU interfaces.
Figure 2-6 All-Weather Connecting Cable Shell Assembly
The provided protective All-Weather Shells fit cables from 3.5mm to 9.0mm diameter.
1. Thread the cable and tight the shell to the ODU firmly by hand (do not use tools).
2. Insert the rubber gasket snugly and tight the connector lock.
Caution:
To avoid accidental damage to the connector, when removing the All-Weather Shell,
unlock the gland first.
2.7.3 Preparing and Weatherproofing the Cable – MultiHaul™ T201
The ODU is provided with rubber gasket (for cables from 3.5mm to 9.0mm diameter)
designed to weatherproof the cable entry to the compact TU housing.
1. To connect the cable to the radio, unlock the Phillips screw at the bottom of the
unit and remove the protective cable housing.
2. Connect the Ethernet RJ45 cable to the radio. Use a miniature cable tie (not
provided) to secure the cable.
3. Positing the rubber gasket and assemble the protective housing.
4. Lock the Phillips screw.
Figure 2-7 All-Weather Connecting Cable Shell Assembly