Operation and Maintenance Manual
MultiHaul™ Installation, Operation and Maintenance Manual
Page 24
2.7 Connecting the Cables – MultiHaul™ T201
1. Ethernet RJ45 cable entry
2. Protective cable housing lock screw
3. Optional ground cable inlet (drilling required)
4. Eth1 RJ45 PoE In
5. ODU LEDs – Eth1, RF and Power
6. Reboot push-button. Restore Factory
Default (push for more than 10 seconds)
7. Optional ground (GND) point
8. Ethernet RJ45 cable
9. Ethernet RJ45 cable tie fixing points
Figure 2-4 MultiHaul™ T201 Connection Panel Details
To connect the cable to the radio, unlock the Phillips screw at the bottom of the unit
and remove the protective cable housing.
Power up the MultiHaul™ T201 by connecting the PoE device to the Eth1 port.