Operation and Maintenance Manual

MultiHaul™ Installation, Operation and Maintenance Manual
Page 18
2 Installing the MultiHaul™ System
This chapter describes how to perform the installation of a MultiHaul™ radio (Base Unit
or Terminal Unit), including:
• Preparing the Site
• MultiHaul™ Package Content
• Unpacking the MultiHaul™
• Required Tools
• Mounting the MultiHaul™
• Connecting the Cables
• System LEDs
• Installing the MultiHaul™
• Link Up Verification and Initial Commissioning
The installation of the MultiHaul™ radio is followed by initial system setup that will be
described in the next chapter.
Caution:
Avertissement:
The installation and maintenance of the MultiHaul™ link should only
be done by service personnel who are properly trained and certified
to carry out such activities.
L'installation et le service de la liaison MultiHaul™ ne doivent être
effectués que par du personnel technique correctement formé et
certifié pour effectuer de telles activités.
Minimum safe distance from antenna while radiating is 32 cm / 12.6
in (general public) or 14 cm / 5.5 in. (occupational) (according to
calculation done based on "Environmental evaluation and exposure
limit according to FCC CFR 47part 1, 1.1307, 1.1310; RSS-102, Safety
Code6).
La distance de sécurité minimale de l'antenne pendant le
rayonnement est de 32 cm / 12,6 po (grand public) ou 14 cm / 5,5 po
(professionnel), selon le calcul effectué sur la base de « Évaluation
environnementale et limite d'exposition selon FCC CFR 47 partie 1,
1.1307, 1.1310 ; RSS-102, Code de sécurité6.
2.1 Preparing the Site
Carefully select and prepare each site to make device installation and configuration as
simple and trouble-free as possible. During site selection and preparation, always
consider the long-term needs of both your network and your applications.