Datasheet

MSDS-No.: 181481
V004.0
TTC-LF 15G RS Page 3 of 5
8. Exposure controls / personal protection
Components with specific control parameters for workplace:
Valid for
Great Britain
Basis
UK EH40 WELs
Ingredient ppm mg/m3 Type Category Remarks
TIN (INORGANIC COMPOUNDS AS SN)
7440-31-5
2 Time Weighted Average
(TWA).
Indicative ECTLV
SILVER (METALLIC)
7440-22-4
0,1 Time Weighted Average
(TWA).
EH40 WEL
SILVER, METALLIC
7440-22-4
0,1 Time Weighted Average
(TWA).
Indicative ECTLV
COPPER, INHALABLE DUSTS AND
MISTS (AS CU)
7440-50-8
2 Short Term Exposure
Limit (STEL):
EH40 WEL
COPPER, FUME
7440-50-8
0,2 Time Weighted Average
(TWA).
EH40 WEL
COPPER, INHALABLE DUSTS AND
MISTS (AS CU)
7440-50-8
1 Time Weighted Average
(TWA).
EH40 WEL
Engineering controls:
Ensure adequate ventilation, especially in confined areas.
Extraction is necessary to remove fumes evolved during reflow.
Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction.
Respiratory protection:
In case of insufficient ventilation, wear suitable respiratory equipment.
Hand protection:
For hand protection, use rubber or plastic gloves.
Eye protection:
Wear protective glasses.
9. Physical and chemical properties
General characteristics:
Appearance Paste
Grey
Odor: Mild
Phys./chem. properties:
pH-value not applicable
Boiling point Not determined
Flash point none
Vapor pressure Not determined
Density
()
3,5 g/cm3
Solubility (qualitative)
(Solvent: Water)
Insoluble
Melting point 217 °C (422.6 °F)
VOC content
(1999/13/EC)
< 1,00 %
10. Stability and reactivity
Conditions to avoid:
Stable under normal conditions of storage and use.