Specifications

MEA-System Manual
6
1.3 Important Safety Advice
Warning: ME- / MEA-Systems include several instruments as individual components. Each
instrument is shipped with a separate Manual. The information in the individual Manuals
fully apply to the complete-System. This manual is only to be understood as an additional
information. Read all Manuals thoroughly before setting up the system.
Warning: Obey always the rules of local regulations and laws. Only qualified personnel
should be allowed to perform laboratory work. Work according to good laboratory practice
to obtain best results and to minimize risks.
The product has been built to the state of the art and in accordance with recognized safety
engineering rules. The device may only
 be used for its intended purpose;
 be used when in a perfect condition.
 Improper use could lead to serious, even fatal injuries to the user or third parties and damage to
the device itself or other material damage.
Warning: The devices and the software are not intended for medical uses and must not be
used on humans.
Malfunctions which could impair safety should be rectified immediately.
High Voltage
Electrical cords must be properly laid and installed. The length and quality of the cords must be in
accordance with local provisions.
Only qualified technicians may work on the electrical system. It is essential that the accident
prevention regulations and those of the employers' liability associations are observed.
 Each time before starting up, make sure that the mains supply agrees with the specifications of
the products.
 Check the power cords for damage each time the site is changed. Damaged power cords should
be replaced immediately and may never be reused.
 Check the leads for damage. Damaged leads should be replaced immediately and may never be
reused.
 Do not try to insert anything sharp or metallic into the vents or the case of the products.
 Liquids may cause short circuits or other damage. Keep the devices and the power cords always
dry. Do not handle it with wet hands.
Electromagnetic compatibility of the MC_Card
The MC_Card data acquisition board is only intended for research work in laboratories. It belongs
to product class 0 conforming to the European Product Regulations and the CE (Conformité
Européenne) marking. The MC_Card complies with all applicable directives specified in the Council
Directive for Electromagnetic Compatibility (89/336/EU).