User guide

Flash Firmware for TA Ports
MultiModemISI Hybrid Server Cards, ISIHP & ISIHI Series 79
5. Select the Baud Rate value in the Configuration menu and press
ENTER.
6. Select 115200 and press ENTER.
7. Select the Device Type value in the Configuration menu and press
ENTER.
8. Select MODEMFILE and press ENTER.
9. Select the Base-Address-for-Port value in the Configuration menu
and press ENTER.
10. Type the base address for the ISI card and press ENTER.
11. Select IRQ Number value in Configuration menu and press
ENTER.
12. Specify the IRQ number for the ISI card and press ENTER.
13. Select the ISI-Port-Number value in the Configuration menu and
press ENTER.
14. Type 1 and press ENTER.
15. Press Escape to back out to the Main Menu.
16. Highlight Select-File-to-Program in the Main Menu and press
ENTER.
17. Select the terminal adapter hex file needed for this ISI card. Then
press ENTER.
18. Select Program Firmware in the Main Menu and press ENTER.
19. Wait until the programming of the terminal adapter is complete.
20. Select Configure in the Main Menu and press ENTER.
21. Select the ISI-port-number value in the Configuration menu and
press ENTER.
22. Type 3 and press ENTER.
23. Press Escape to back out to the Main Menu.
24. Highlight Select file to Program in the Main Menu and press
ENTER.