User guide

Software/Driver Installation (SCO Open Server)
58 MultiModemISI Hybrid Server Cards, ISIHP & ISIHI Series
To install driver from floppy disk
(Users starting with the untarred SCO5 driver on a floppy disk can
begin the installation here).
1. Run the custom utility.
2. Select Software.
3. Select Install New.
4 Highlight driver file from local host and select Continue.
5. Select as the Media Device Floppy Disk Drive.
6. Select Continue.
7. Highlight Multi-Tech ISA/PCI ... and select Install.
8. Enter Y (yes) to continue installing the ISI driver.
9. As many as four ISI cards can be installed in the server.
9a. If you are installing an ISIHP card, type 0 (that is, zero).
9b. If you are installing an ISIHI card, type 1, 2, 3, or 4,
based on the number of ISIHI cards you are installing in your system.
Type the base I/O address and the IRQ value for each card. Be sure
that the I/O address and the IRQ value match the values set in the DIP
switch and jumper block on the ISIHI card.
For further details see MultiTech Installation Script step 1.
10. Type the number of pseudo-devices to be created.
For the ISIHP-1S, type 4.
For the ISIHP2S/2U/4SD and ISIHI-2S/2U, type 8.
For ISIHP-4S/4U, type 16.
For further details see MultiTech Installation Script step 2.
11. Type Y (yes) to accept the prefix for tty ports. For further details
see MultiTech Installation Script step 3.
12. Type Y (yes) to confirm the selection. For further details see
MultiTech Installation Script step 4.