User guide

Software/Driver Installation (Novell Netware)
MultiModemISI Hybrid Server Cards, ISIHP & ISIHI Series 55
LOAD AIOISIX [port=W] [interrupt=X] [name=Y]
[note=Z]
For PCI-bus cards (ISIHP models) Netware will set up the interrupt
(IRQ) and I/O address automatically.
To install the ISI card scripts, copy aiomdms.mdc to
f:\system\aio\directory. Click Yes to overwrite the existing
aiomdms.mdc file.
Configuring Ports for NetWare Connect
When the driver is installed, it will allocate consecutive ports for the
ISI card as follows:
 16 consecutive ports for the ISIHP-4S/4U/4SD. Note that, for the
ISIHP-4SD, only 8 of these ports will be used; the other 8 ports will
be considered broken. After installation of the ISIHP-4SD is
complete, the broken ports can be allocated to a different purpose.
 8 consecutive ports for the ISIHI-2S/2U or ISIHP-2S/2U
 8 consecutive ports for the ISIHP-1S. However, upon inspection, the
Netware OS will initialize the first pair of ports (terminal adapters),
label the second pair of ports broken, initialize the third pair of
ports (modems), and label the fourth pair broken. After installation
of the ISIHP-1S card is complete, the broken ports can be allocated
to a different purpose.
To set up NetWare Connect ports, enter LOAD NWCCON at the
NetWare console prompt. LOAD NWCCON opens the NetWare
Connect Configuration Utility. Select the appropriate menu options
(modem type, speed, flow control, etc.).
Removing the Driver (Novell)
In Novell, remove file AIOISIX.NLM from the system directory and
make the appropriate changes to the Autoexec.ncf file.