User guide

Configuring Terminal Adapters
MultiModemISI Hybrid Server Cards, ISIHP & ISIHI Series 51
10. The Welcome dialog box appears. Click Next.
11. The Searching for TA dialog box appears. Click Next.
The next dialog box specifies the TA that has been identified.
12. The Configuration dialog box appears. If you have questions
about choices, click Help. After entering information in each
dialog box, click Next.
13.The SPID dialog box appears (North America only). Referring to
your network configuration notes, enter the appropriate informa-
tion; then click Next.
14. The Data Protocol Setup dialog box appears. Referring to your
network configuration notes, enter the appropriate information;
then click Next.
15. In the Save Configuration dialog box, enter a name to store the
configuration. Then click Next.
16. To load the configuration, click Next in the Load Configuration
dialog box.
17. Then click Finish in the Configured dialog box.
18. The first TA now is configured. Click Back to return to the
Configuration dialog box and repeat steps 4 through 9 to
configure the remaining TA(s). If you install multiple ISIHI or
ISIHP cards in the same PC, you must configure two TAs per 2S or
2U card installed or four TAs per 4S, 4U, or 4SD card. For the
ISIHP-1S, you configure only one TA. For example, if you install
four ISIHP-2S/2U cards in one PC, you have to configure eight
TAs (two per card).
19. After all TAs are configured, close the ISDN TA Configuration
utility.