User guide

Software/Driver Installation (Windows 2000)
MultiModemISI Hybrid Server Cards, ISIHP & ISIHI Series
37
Remove ISIHx Driver (Windows 2000)
1. Go to Start | Settings | Control Panel.
2. Click on Add/Remove Hardware. Click Next.
3. Click on Uninstall/Unplug a device and click Next.
4. In the subsequent screen, click on Uninstall a device and click
Next.
5. At the Add/Remove Hardware Wizard screen, highlight the ISI
driver file for the specific server card that you intend to remove.
Click Next.
6. When you are asked to confirm removal, click on the Yes radio
button and click Next.
7. Click Finish. You can remove the driver for only one ISIHx card at
a time.
ISIHx Software Installation Procedure for
Windows NT 3.51/4.0
1. Turn off the PC.
2. The ISIHx card must be installed in an expansion slot in the PC. If
not, follow the PC manufacturer's instructions concerning
installation of expansion cards. Observe standard precautions
regarding electro-static discharge (ESD) when handling the ISIHx
board (the board should be kept in its shipping bag until used).
During installation, handle the ISIHx circuit card by its edges and
keep one hand in contact with the PC chassis.
For ISIHP cards. Install the ISIHP card in an available PCI
expansion slot in the computer.
For ISIHI cards. Install the ISIHI card in an available ISA
expansion slot in the computer. Set the Base I/O Address and the
Interrupt Request (IRQ) values per the table below: