User guide
Software/Driver Installation (Windows 2000)
26 MultiModemISI Hybrid Server Cards, ISIHP & ISIHI Series
Introduction
This chapter describes software/driver installation for the ISI cards
when used in Windows 2000, Windows NT4, Windows NT3.51,
Novell, Linux, and SCO Open Server 5. We also describe installation
of MultiTechs Management Software for use with ISI cards under
Windows 2000.
Installing ISIHI Software for Windows 2000
1. Turn off the PC.
2. The ISIHI card must already be installed in an ISA expansion slot in
the PC. If it is not, follow the PC manufacturer's instructions
concerning installation of expansion cards. Observe standard
precautions regarding electro-static discharge (ESD) when handling
the ISIHI board (the board should be kept in its shipping bag until
used). During installation, handle the ISIHI circuit card by its edges
and keep one hand in contact with the PC chassis. Set the Base I/O
Address and the Interrupt Request (IRQ) values per the table
below:
Recommended Base I/O Address and IRQ Values
ISIHI-2S/2U Base I/O Address IRQ
Initial 8 port board 210h 10
First 8 port upgrade 220h 11
Second 8 port upgrade 230h 12
Third 8 port upgrade 240h 15
The I/O Address DIP Switch is on the endplate of the ISIHI; the IRQ
Jumper Block is on the component side of the circuit card, lower
middle area.
3. Turn on the PC and start Windows 2000.
4. Insert the ISI installation CD into the CD drive in your computer (in
cases where the driver files have been downloaded from the Multi-
Tech web site and copied onto diskette, insert the diskette into the
floppy drive now).