Owner`s manual

Software/Driver Installation
50 MultiModemISI Hybrid Series, ISIHI-2S/2U
support and an upper case X value for modem control for each port you
want to enable. The port status can be altered later, but one setting must
be selected at this time.
5. Repeat this process for each port on each board you have installed.
Record the setting you select for each port.
6. Using device names created in the previous section, type the following
command for each port you want to activate: enable ttylbx
7. Repeat this command for each port you want to activate, using the
lower case letter for local terminal use or upper case for modem
control.
Note: Only one of the options (e.g., modem control or local terminal
access) should be enabled for any port at one time. For example, you
cannot enable ttyl1a and then enable ttyl1A. To change the status of a
port, disable the current status (disable ttyl1a) and then enable it for
the desired status (enable ttyl1A).
Removing the Driver (SCO Open Server 5)
To remove the Multi-Tech Serial Card Driver, you should enter the
configuration utility (e.g., custom for SCO Open Server 5) and follow the
instructions to remove the entire driver and rebuild the kernel without the
ISI driver. If it is necessary to reinstall the driver due to I/O address or IRQ
overlap, remove the driver first.
Multi_Setup Utility
This section guides you through the Multi_View Utility for SCO and
UNIXWare systems. While installing the ISIHI-2S/2U drivers, you also
install the Multi_View utility for multiple page terminals. This section
profiles the Multi_View utility and gives you the necessary information to
create a Multi_View information file.
Once installed, Multi_View can be opened by typing the following
command:
Multi_View [options]
Multi_View initializes the multiple page capacity of terminals with multiple
pages of memory. While Multi_View works even on a dumb terminal
(without multiple pages of memory), your terminal should have multiple