Owner`s manual
Software/Driver Installation
MultiModemISI Hybrid Series, ISIHI-2S/2U 49
messages displays while the driver is being installed and the kernel
rebuilt. When the display finishes, press ENTER to continue. When
Installation complete displays, press ENTER .
10. Select Host and press ENTER. Remove the diskette from the drive.
11. Select Exit and press ENTER.
12. To reboot the system, enter the following commands:
Type sync and press ENTER.
Type sync again and press ENTER.
Type haltsys and press ENTER.
Driver installation for the ISIHI-2S/2U card now is complete.
Activating Ports in SCO Open Server 5
SCO Open Server 5 provides a device database that monitors the activity of
serial ports through which users can log onto the host. If your ISI ports are
used by terminals (e.g., to allow users to log onto your host), you must
create an entry in the systems device database that furnishes specific
information for the terminals that will be used on each ISI port. The
database is referenced each time a user attempts to log in. If there is no
database entry for a particular terminal, access to the host is denied.
1. Turn on your system, noting that the firmware for each ISIHI-2S/2U
loads successfully. If the firmware for a given ISIHI card does not load,
none of its ports will be accessible. (If this happens, see Multi-Techs
Administrative Utility section in the online manual.)
2. The device database can be modified in two ways:
To create terminal accounts with default settings, type /tcb/bin/
ttys_update.
To customize terminal entries, you must create them individually by
entering the system administrators shell (you must be logged in as
the root user). To enter the administrators shell, type sysadmsh and
press ENTER.
3. Create device entries for each port of the ISI card by selecting the
following from the database menu: Accounts, Terminal, Create.
4. Type the complete name of the first device you want to create,
substituting the base name, board number, and port letter for the
parameters: ttylb. Use a lower case x value for local DTE (terminal)