Owner`s manual

Software/Driver Installation
48 MultiModemISI Hybrid Series, ISIHI-2S/2U
The default base name for ISIHI-2S/2U ports is ttyl. The default base
name for printer ports is prnl. If this is acceptable, type Y and press
ENTER.
To change the base name, type N and provide a prefix of less than five
characters. The base name you select will be used for all ports on each
card you install.
The following describes the format used in naming ISI ports:
Default device name and format: ttyl
ttyl BASENAME
This prefix is applied to all ISI ports on all boards. Base names
contain 14 characters.
b BOARD NUMBER
Values of 1 through 4, depending on the number of cards installed.
x PORT LETTER
Values of AH for ISI ports. (SCO UNIX values AH indicate
modem ports.)
Device base name selected: _________________
7. After you select a device base name, you are prompted for a printer
base name. This prefix identifies each port that supports a terminal with
a printer attached to its auxiliary port (for transparent printing). Select a
unique base name or accept the default of prnl (printer parameters are
outlined in the Multi_Setup Utility section in this guide).
Printer base name selected: _________________
8. The Multi_View utility initializes the multiple-page capability of
terminals with multiple pages of memory. You are asked how many
pseudo devices (the total number of pseudo devices you want to make
available to the Multi_View utility) to create. This is the total number
of devices available to all Multi-Techs terminals. You can have a
maximum of 256 pseudo devices in your system.
9. The confirmation screen lists the values you selected. If these values
are correct, type Y and the installation process continues.
If there is an error in any of the values displayed, type N and the first
screen displays. You must then reenter the information for each card.
When you accept the confirmation list (by typing Y), a series of