Owner`s manual

Software/Driver Installation
46 MultiModemISI Hybrid Series, ISIHI-2S/2U
SCO Open Server 5 Driver Installation
The installation utility provided by SCO is called custom. This section
provides a brief guide for opening the utility and installing the driver. The
instructions below should be used only on SCO Open Server 5 systems.
When you have completed the steps below, go to Multi-Tech Installation
Script, which immediately follows this section.
1. If installing the driver from your default floppy drive, type custom and
press ENTER to open the custom utility. If using a nondefault drive,
you must inform your system of the disk drive from where you are
doing the installation and the size and capacity of the diskette(s).
2. Select Software and press ENTER.
3. The main menu displays a list of options. Press ENTER to select the
highlighted item (default): Install.
4. Select From comsco and press ENTER.
5. Make sure the driver diskette is in the floppy diskette drive and then
press ENTER to select the highlighted item (default): Floppy Disk
Drive 0. The following message appears:
Examining media. Please wait 
6. The system recognizes you are installing the Multi-Tech Serial Card
Driver and prompts you to select the type of installation.
7. Select Full Installation and press ENTER to continue. The following
messages appear:
Extracting Files...
Executing Multi-Tech Serial Card Driver Init Script...
8. When installation finishes, this prompt appears:
Do you wish to continue ( y / n / q ):?
Type Y and press ENTER. Proceed with the next section, Multi-Tech
Installation Script.
The Multi-Tech Installation Script
This section guides you through the Multi-Tech Installation Script for SCO
and UNIXWare systems. The script requests information such as how many
boards you want to install, what I/O address and IRQ values (interrupt
requests) you have selected, and how many pseudo devices you want to
create for Multi_View utility. This information extracts the necessary