Owner`s manual
Software/Driver Installation
MultiModemISI Hybrid Series, ISIHI-2S/2U 43
ConfigMenu Configuration Utility
Use the ConfigMenu configuration utility with computers using DOS or
Windows 3.x operating systems. ConfigMenu is installed in the TAs as part
of the firmware.
To use ConfigMenu:
1. Start a data communication program and select the COM port where
the TA is connected.
2. In the communication program dialog box, type AT@CONFIG and
press ENTER. ConfigMenuî‚’s Main Menu appears (see screen below).
3. To select menu item, type its number and press ENTER. A submenu
then appears where you can make selections. At the lowest level, you
can change a configuration option by selecting a number or typing a
value and pressing ENTER.
4. When you finish, close ConfigMenu.
5. Use the &W command to save your new configuration and to load it
automatically when the TA is turned on.