Owner`s manual

Software/Driver Installation (Windows NT)
MultiModemISI Hybrid Series, ISIHI-2S/2U 11
Software/Driver Installation: Introduction
This section contains general instructions for software/driver installation in
Windows NT, Windows 95, Novell, and SCO Open Server 5, and Linux.
This guide assumes installers have a thorough knowledge of their operating
system and the software installation process; therefore, it does not include
every screen or option involved in installing and configuring the drivers.
Installing ISIHI-2S/2U Drivers in Windows NT
1. Click Start, Settings, Control Panel, and then double-click the Add/
Remove Programs icon.
2. The Add/Remove Program Properties dialog box appears.
In the Install/Uninstall tab, click Install.
3. The Install Program From Floppy Disk or CD-ROM dialog box
appears. If installing from diskette, insert diskette labeled MultiModem
ISI Driver for Windows NT in the disk drive. Then click Next.
(If installing from a network location, connect to it. Note drive; you
may need it later if you run Setup again.)