user manual

Part 3 – AT Commands Wi-Fi Devices Chapter 13 – WLAN AT Commands for the SocketWireless Wi-Fi
Universal IP AT Commands Reference Guide (Document S000457K) 66
#WLANSCANMODE – Scanning Mode
Description: Sets scanning mode. The module can work in both active scanning and passive scanning modes.
In active scanning, the module actively sends a probe request to associate with the AP, and in
passive scanning, the module waits for a beacon from the AP and then it associates.
Note: The module must be reset to put the command into effect.
Syntax: AT#WLANSCANMODE =<value>
AT#WLANSCANMODE? Read or display the current setting.
Values: 0 - Active scanning
1 - Passive scanning
Default: 0 Active scanning
#WLANSSID – SSID of WLAN
Description: Sets the WLAN network SSID.
Note: The module must be reset to put the command into effect.
Syntax: AT#WLANSSID ="<value>"
AT#WLANSSID? Read or display the current setting.
Values: Alphanumeric ASCII Text String of up to 32 characters. It will take a blank space also.
Default: mt810swm_disable
#WLANDATARATE – WLAN Transmission Data Rate
Description: Sets the WLAN transmission data rate. "Auto" can be used for auto data rate during data transfer.
Note: The module must be reset to put the command into effect.
Syntax: AT#WLANDATARATE=<value>
AT#WLANDATARATE? Read or display the current setting.
Values: Auto, 1, 2, 5.5, 9, 11, 12, 24, 36, 48, 54 (in Mbps)
Default: 11 (in Mbps)
#WLANIBSSCHANNEL – Channel for Ad-Hoc Mode
Description: Sets channel for Ad-Hoc mode.
Note: The module must be reset to put the command into effect.
Syntax: AT#WLANIBSSCHANNEL=<value>
AT#WLANIBSSCHANNEL? Read or display the current setting.
Values: 1 – 13 (See Country Code for limit)
Default: 9