user manual

Part 1 – AT Commands for All Universal IP Devices Chapter 7 – PING AT Commands
Universal IP AT Commands Reference Guide (Document S000457K) 47
Chapter 7 – PING AT Commands for All
Universal IP Devices
Set Commands
General Note: Due to varying factors, PING response times may not be valid.
#PINGNUM – Number of PING Requests
Description: This command sets the number of PING echo requests to issue to PINGREMOTE.
Syntax: AT#PINGNUM=<Value>
AT#PINGNUM? Read or display the current setting.(or AT#VPING, AT#VALL).
Values: From 0 to 255 inclusive. (If 0, ping indefinite until ETX (0x03) is issued)
Default: 4
#PINGREMOTE – IP Address of PING Request
Description: Sets the IP address up of the remote device to ping.
Syntax: AT#PINGREMOTE="<IP Address Value>"
AT#PINGREMOTE? Read or display the current setting.(or AT#VPING, AT#VALL).
Values: 32-bit number is dotted-decimal notation (i.e., xxx.xxx.xxx.xxx). No default.
#PING – Start PING Request
Description: Directs the module to start PING requests to the configured PING remote address. No of
requests to be sent is obtained from the PINGNUM parameter.
Syntax: AT#PING
AT#PING? Read or display the current setting.
Values: Read parameters: (read from serial flash predefined before starting the ping command.)
PINGNUM
PINGREMOTE
#PINGDELAY – PING Delay Time
Description: This command sets the waiting delay, in seconds, before an echo request is considered as a no
reply. It is also the delay between two echo requests (if PINGNUM > 1).
Syntax: AT#PINGDELAY=<Value>
AT#PINGDELAY? Read or display the current setting.
Values: From 1 to 255 inclusive.
Default: 1