User Guide ISDN Terminal Adapter MTA128ST-USB

37
Chapter 3 - Software Installation and Configuration
• V.110 Protocol*—Used to connect slower, pre-ISDN communications devices to high-speed
ISDN lines. It handles rates up to only 38400 bps and is used mostly in Europe. The devices
on both ends of the link must be set to identical rates. However, the MTA128ST-USB (by
default) is able to adapt to the network rate of a received V.110 call even though it has S76 or
$MB set to a different network rate.
* The MTA128ST-USB is manufactured in two builds. To determine the build of your terminal
adapter (TA), issue the ATI2 command in a terminal window. If the TA responds to the command
with MTA128ST-USB, then it supports V.110. If your TA resonds to the ATI2 command with
MTA128ST-USB-RC, V.110 support is not available.
• V.120 Protocol—Similar to V.110 protocol, but provides rates up to 64000 bps on each B
channel.
• X.75 Protocol—Packet-switched network protocol for international use. Layer 2 portion of this
protocol is used commonly as a rate adaption protocol.
• MLPPP Protocol—MLPPP (Multi-Link PPP) protocol provides rates up to 64 Kbps per
channel. This protocol uses both B channels at once, providing an aggregate data
transmission speed of 128 Kbps.
Dialing Numbers _____________________________
The MTA128ST-USB can dial telephone number n , where n can be up to 20 characters. AT command:
Dn ( n = phone number)
Stored Numbers _____________________________
The MTA128ST-USB can store as many as ten phone numbers, up to 20 characters each. AT
command: &Z=
Dialing Stored Numbers _______________________
The MTA128ST-USB can dial a number previously stored in directory number n with the &Zn=x
command. AT command: DSn