Voice Messaging Modem MT5634MSV

ManualsBrandsMulti-Tech Systems ManualsNetwork CardMT5634MSV

4 AT Commands, S-Registers, and Result Codes

Result Codes

In command mode your modem can send responses called result codes to your com-

puter. Result codes are used by communications programs and can also appear on

your monitor.

Terse Verbose Description

0OK Command executed

1 CONNECT Modem connected to line

2RING Ring signal detected

3 NO CARRIER Carrier signal lost or not detected

4 ERROR Invalid command

5 * CONNECT 1200 Connected at 1200 bps

6 NO DIALTONE No dial tone detected

7 BUSY Busy signal detected

8 NO ANSWER No answer at remote end

10 * CONNECT 2400 Connected at 2400 bps

11 * CONNECT 4800 Connected at 4800 bps

12 * CONNECT 9600 Connected at 9600 bps

13 * CONNECT 14400 Connected at 14400 bps

14 * CONNECT 19200 Connected at 19200 bps

24 * CONNECT 7200 Connected at 7200 bps

25 * CONNECT 12000 Connected at 12000 bps

26 * CONNECT 16800 Connected at 16800 bps

40 * CONNECT 300 Connected at 300 bps

55 * CONNECT 21600 Connected at 21600 bps

56 * CONNECT 24000 Connected at 24000 bps

57 * CONNECT 26400 Connected at 26400 bps

58 * CONNECT 28800 Connected at 28800 bps

59 * CONNECT 31200 Connected at 31200 bps

60 * CONNECT 33600 Connected at 33600 bps

70 * CONNECT 32000 Connected at 32000 bps, 56K rate

71 * CONNECT 34000 Connected at 34000 bps, 56K rate

72 * CONNECT 36000 Connected at 36000 bps, 56K rate

73 * CONNECT 38000 Connected at 38000 bps, 56K rate

74 * CONNECT 40000 Connected at 40000 bps, 56K rate

75 * CONNECT 42000 Connected at 42000 bps, 56K rate

76 * CONNECT 44000 Connected at 44000 bps, 56K rate

77 * CONNECT 46000 Connected at 46000 bps, 56K rate

78 * CONNECT 48000 Connected at 48000 bps, 56K rate

79 * CONNECT 50000 Connected at 50000 bps, 56K rate

80 * CONNECT 52000 Connected at 52000 bps, 56K rate

81 * CONNECT 54000 Connected at 54000 bps, 56K rate

82 * CONNECT 56000 Connected at 56000 bps, 56K rate

88 DELAYED Delay is in effect for the dialed number

89 BLACKLISTED Dialed number is blacklisted

EC is added to these result codes when the extended result codes configuration option is enabled. EC is re-

placed by one of the following codes, depending on the type of error control connection:

V42bis —V.42 error control (LAP-M) and V.42bis data compression

V42 —V.42 error control (LAP-M) only

MNP5 —MNP 4 error control and MNP 5 data compression

MNP4 —MNP 4 error control only

NoEC —No error control protocol).