User Guide Data/Fax/Voice Messaging Modem MT5634MSV

MessageSaver User Guide
40
Command: \V n Protocol Result Code
Values: n = 0, 1, or 2
Default: 1
Description: \V0 Disable the appending of the protocol result code to the DCE
speed.
\V1 Enable the appending of the protocol result code to the DCE
speed.
\V2 Same as \V1.
Command: \X n XON/XOFF Pass-Through
Values: n = 0 or 1
Defaults: 0
Description: \X0 Modem responds to and discards XON/XOFF characters.
\X1 Modem responds to and passes XON/XOFF characters.
Command: -C
n Data Calling Tone
Values: n = 0 or 1
Defaults: 0
Description: -C0 Disable V.25 data calling tone to deny remote data/fax/voice
discrimination.
-C1 Enable V.25 data calling tone to allow remote data/fax/voice
discrimination.
Command: %B View Numbers in Blacklist
Values: n/a
Description: If blacklisting is in effect, AT%B displays the numbers for
which the last call attempted in the previous two hours failed.
In countries that do not require blacklisting, the ERROR result
code appears.
Command: %C
n Data Compression Control
Values: n = 0 or 1
Default: 1
Description: %C0 Disable V.42bis/MNP 5 data compression.
%C1 Enable V.42bis/MNP 5 data compression.
Command: %DC n AT Command Control
Values: n = 0 or 1
Default: 0
Description: %DC0 The modem responds to AT commands.
%DC1 The modem ignores AT commands.
Note: The modem will respond to AT%DC for 10 seconds after power-up.
Command: %E n Fallback and Fall Forward Control
Values: n = 0, 1, or 2
Default: 2
Description: %E0 Disable fallback and fall forward.
%E1 Enable fallback, disable fall forward.
%E2 Enable fallback and fall forward.