User Guide MultiModem MT2834MR6

103
Appendix
&RFn n = 0 or 1 CTS/RTS Interaction Control
&RF0 Let CTS follow RTS.
*** &RF1 Let CTS act independently.
&RN n/a Rate Renegotiation
Forces the modem to renegotiate the data rate.
&RP n/a Immediate Line Probe
Initiates a retrain that makes the modem read line probe information if %DP1 is
selected. Valid only when online in V.34 mode.
&RR n/a Retrain
Initiates an immediate retrain without a line probe reading.
$Rn n = 0 or 1 Retransmit Count
*** $R0 Disconnect after 12 retransmits.
$R1 Do not disconnect after 12 retransmits.
Sr=n r = 0–11, 13, Set Register Value
24, 25, 30, Set value of S-register r to value of n , where n is entered in decimal format.
32, 34, 36,
37, 43, 48, or
94; n varies
Sr? r = 0–11, 13, Read Register Value
24, 25, 30, Read value of S-register r and display value in 3-digit decimal form.
32, 34, 36,
37, 43, 48,
or 94
&Sn n = 0, 1, or 2 Data Set Ready Control
&S0 Force DSR high (on).
*** &S1 Let DSR follow CD.
&S2 DSR drops on disconnect for time set by S24 , then goes high again.
&SFn n = 0 or 1 DSR/CD Interaction Control
*** &SF0 Select DSR to follow CD.
&SF1 Select DSR to be independent.
$SBn n = speed Serial Port Baud Rate
Baud Adjust $SB300 Select 300 bps at serial port.
($BA) must $SB1200 Select 1200 bps at serial port.
be off. $SB2400 Select 2400 bps at serial port.
$SB4800 Select 4800 bps at serial port.
$SB9600 Select 9600 bps at serial port.
$SB12000 Select 12,000 bps at serial port.
$SB19200 Select 19,200 bps at serial port.
$SB38400 Select 38,400 bps at serial port.
$SB57600 Select 57,600 bps at serial port.
*** $SB115200 Select 115,200 bps at serial port.
#Sy y = password Enter Setup Password
Password is case sensitive.
#S=y y = password Store Setup Password
Password must be 6–10 characters long, and may consist of any keyboard charac-
ters.
T In dialing Tone-Dial
command Modem tone-dials numbers following the T.