User Manual

Chapter 3—Driver Installation

5. To verify that the files have been copied onto the floppy disk, use these commands:

# scosh

- Select Manager.

- Select Archive.

- Select List.

- Make sure Device is pointed to the floppy disk.

- Select Continue.

To install driver from floppy disk

(Users starting with the untarred SCO5 driver on a floppy disk can begin the installation here).

1. Run the custom utility.

2. Select Software.

3. Select Install New.

4. Highlight driver file from local host and select Continue.

5. Select as the Media Device “Floppy Disk Drive.”

6. Select Continue.

7. Highlight “Multi-Tech ISA/PCI ...” and select Install.

8. Enter Y (yes) to continue installing the ISI driver.

9. As many as four ISI cards can be installed in the server. Regardless of how many cards you

will install in your server, type 0. (Because the ISI5634PCI cards are PCI-equipped, SCO can detect the

cards and will set up I/O addresses and IRQ values as needed.

For further details see MultiTech Installation Script step 1.

10. Type the number of pseudo-devices to be created.

For the ISI5634PCI-4, type 4.

For the ISI5634PCI-8, type 8.

For further details see MultiTech Installation Script step 2.

11. Type Y (yes) to accept the prefix for tty ports. For further details see MultiTech Installation Script

step 3.

12. Type Y (yes) to confirm the selection. For further details see MultiTech Installation Script step 4.

13. After the driver is installed, press <ENTER> to continue. For further details see MultiTech Installation

Script step 4(last paragraph) and step 5.

14. Exit the custom utility. For further details see MultiTech Installation Script step 6.

15. Remove the floppy disk and reboot your computer. For further details see MultiTech Installation

Script step 7.