User Manual

11
Chapter 2—Hardware Installation
Installing the ISI5634PCI card WITH the auxiliary module:
1. The auxiliary module attaches to the ISI5634PCI card. If you already have this card installed, you
must remove it from the PC to install the auxiliary module.
2. Before handling the ISI5634PCI card or the auxiliary module, discharge any static in your body by
touching a piece of grounded metal such as the computer chassis.
3. Carefully remove the ISI5634PCI card and module from the antistatic bag, handling only by the
mounting bracket and edges. Do not touch the gold-plated connectors along the bottom edge. (You
may want to save packaging for possible future use.)
4. Visually inspect the ISI5634PCI card and the auxiliary module. If you have any concerns about its
condition, call Technical Support at (800) 972-2439.
5. To avoid damaging the card, module, or your PC, make sure your computer and any peripheral
equipment connected to it are turned off. The ISI5634PCI and auxiliary module can be installed in
any Pentium equivalent PCI bus computer.
6. Remove the cover of your computer as instructed in your computer’s documentation.
7. Before installing the ISI5634PCI card, carefully line up the pin-out connectors of the ISI5634PCI
card with the pin-out connectors of the auxiliary module. See figure below.
Mounting screws
Mounting posts
Pin-out
connectors
8. Press gently but firmly to seat the module onto the card.
9. Fasten the mounting connections (four screws) of the auxiliary module to the ISI5634PCI card. See
figure above.
10. Install the ISI5634PCI card into the selected expansion slot in the same manner as any other add-on
card, as instructed in your computer’s documentation.
11. Fasten the retaining bracket to computer chassis and replace cover.
12. Plug one end of the phone cable into each modem’s LINE jack and the other end into a phone line
wall jack.
13. Turn on the power to the computer. You now are ready to install your drivers.
Note: The LINE jack is not interchangeable with the wall jack. Do not plug the phone into the LINE jack or
the line cable into the wall jack.
Note: The Federal Communications Commission (FCC) and Industry Canada impose certain restrictions
on equipment connected to public telephone systems. Refer to Appendix A—Regulatory Information
for more information.