User Manual

50
ISI5634PCI/4/8 User Guide
4. Using device names created in the previous section, type the following command for each port you
want to activate: enable ttylbx
5. Repeat this command for each port you want to activate, using the lower case letter for local terminal
use or upper case for modem control.
Note: Only one of the options (e.g., modem control or local terminal access) should be enabled for any
port at one time. For example, you cannot enable ttyl1a and then enable ttyl1A . To change the
status of a port, disable the current status ( disable ttyl1a ) and then enable it for the desired
status ( enable ttyl1A ).
Removing the Driver (SCO Open Server 5)
To remove the ISI Driver, enter the configuration utility (e.g., custom for SCO Open Server 5) and follow
instructions to remove the entire driver and rebuild the kernel without the ISI driver. If it is necessary to
reinstall the driver due to I/O address or IRQ overlap, remove the driver first.
Note: Remove the driver before permanently removing the ISI card from the computer.