S01-051J USER MANUAL May 11, 2022
Table 1 Revision history ..................................................................................................................
TABLE OF CONTENTS 1 VERSION HISTORY ......................................................................................................................... 4 2 USER MANUAL ................................................................................................................................. 5 2.1 PRODUCT DESCRIPTION ............................................................................................................................. 5 2.2 PRODUCT INSTALLATION .....................
1 VERSION HISTORY Table 1 Revision history Revision Date Modified By Description 1.0 March 31, 2022 Tuan A. Pham 1st Draft 1.1 April 1, 2022 Tuan A. Pham Updated details 1.2 April 5, 2022 Tuan A. Pham Updated section 2.4 & 2.5 1.3 April 6, 2022 Tuan A. Pham Updated section 2.4 & 2.5 1.4 May 11, 2022 Tuan A. Pham Fixed typo in section 2.4 MULTITECH SYSTEMS, INC.
2 2.1 USER MANUAL PRODUCT DESCRIPTION The module S01-051J is a PCB module which has an interface to connect to an external IR sensor and control external solenoid valve. The module has Bluetooth Low Energy (BLE) capability to be able to communicate with Phone Applications via BLE radio to configure the settings for valve control and provide collective device and sensor data. The module can be powered via 6VDC battery or external power adapter (6VDC/24VAC).
2.4 REGULATORY INFORMATION CANADA ISED Regulatory Statements IC: 125A-0068 This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
USA FCC Regulator Statements FCC: AU792U22C01871 Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
FCC & ISED RF RADIATION EXPOSURE STATEMENT This equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment. To comply with FCC and ISED RF radiation exposure limits for general population, the antenna(s) used for this transmitter must be installed such that a minimum separation distance of 20 cm is maintained between the radiator (antenna) and all persons at all times and must not be co-located or operating in conjunction with any other antenna or transmitter.
2.5 HOST PRODUCT LABELLING This module is labeled with its own FCC ID and ISED Certification Number. If the FCC ID and ISED Certification Number are not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. In that case, the final end product must be labeled in a visible area with the following: \ Contains FCC ID: AU792U22C01871 Contains IC: 125A-0068 This device complies wi
This is the Last Page of this Document MULTITECH SYSTEMS, INC.
