User's Guide

Chapter 2 – Installation
Multi-Tech Systems, Inc. MultiModem® EDGE Wireless Modem User Guide 18
6. Plug the power supply cable into the modem.
Connect antenna.
Connect serial cable
between modem & PC.
A
B
Connect power
(AC or DC).
C
Fused DC
Power Cable
In-Line
Fuse
red wire
is positive
( + )
AC adaptor
(N. Amer. only)
AC
adaptor
(Int’l)
7a. For two-piece transformer power supply (International).
Connect the AC cord receptacle into the transformer block.
Connect the AC cord plug into the mains power outlet.
7b.
For one-piece transformer power supply (North America).
Connect between the MultiModem power receptacle and the mains power outlet.
7c.
For optional direct-DC powering.
Connect the direct-DC power supply cable into the DC power source on the vehicle or
machine in which you are mounting the modem. Be sure the GND connection is correct.
Connect red wire to + (positive) and black wire to – (negative).
Note:
Units shipped with either the one-piece or two-piece AC power supply are not suited for installation
in hazardous locations.
Note: For automotive application: according to the type of application, you can use permanent “+” or key-
switched “+”. Connect the power supply to its source (for example, in a mobile situation, to the
vehicle’s DC fuse/terminal block).
8. Activate the power supply.